![]() In the same year, the team went to Silicon Valley and successfully raised 1.6 million dollars from Kickstarter backers from all over the world. In the beginning, the team had gathered people talented in different fields, including hardware, software, and design. The FLUX team was founded in Taipei in March 2014. This long-lasting filter will need to be replaced after every 300 – 600 hours of use. This filter can eliminate almost all of the particles at this point, allowing for the Beam Air to be a proficient fume extractor. Particles have to make it past three other filters to reach this one. This is the bottom filter, or final filter, of the Beam Air. This filter will need to be replaced after every 100 – 200 hours of use. The third section of the Beam Air is known as the H13 HEPA Filter and as it is near the center of the Beam Air, it filters out the few remaining particles that may have penetrated past the other two filters. To ensure the Beam Air is eliminating as many particles from passing to the outside environment, this filter will need to be replaced after every 50 – 150 hours of use. Just below the pre-filter, the medium efficiency filter provides a buffer and further filtering out particles which managed to get through the pre-filter. ![]() ![]() Because this filter is the thinnest and the top layer, this filter will need to be replaced after every 10 – 30 hours of use. This is the first layer of defense! The pre-filter is positioned on the top of the Beam Air, so it is the first filter that will be preventing particles from passing through – coming from the laser cutter which is connected via a tube.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |